Filter
Top Products
1312
CClleeaanniinngg aanndd MMaaiinntteennaannccee
Any piece of equipment works better and lasts longer when maintained
properly and kept clean. Cooking equipment is no exception. Your
oven must be kept clean and maintained properly.
CCoonnttrrooll KKnnoobb
MAKE SURE THE CONTROL KNOB POINTS TO THE OFF POSITION
BEFORE REMOVING. Pull the knob straight off. Wash in detergent
and warm water. Do not soak the knob. Dry completely and replace
by pushing firmly onto stem. DO NOT USE any cleaners containing
ammonia or abrasives. They could remove the graphics from the knob.
SSttaaiinnlleessss SStteeeell PPaarrttss
All stainless steel parts should be wiped regularly with hot, soapy water
at the end of each cooling period and with liquid stainless steel cleaner
when soapy water will not do the job.
DDoo nnoott uussee
steel wool, abrasive
cloths, abrasive cleaners, or powders. If necessary to scrap stainless
steel to remove encrusted materials, soak the area with hot towels to
loosen the material, then use a wooden or nylon spatula or scraper.
DDoo nnoott uussee aa mmeettaall kknniiffee,, ssppaattuullaa,, oorr aannyy ootthhe
err mmeettaall ttooooll ttoo ssccrraappee
ssttaaiinnlleessss sstteeeell.. FFoorr ooccccaassiioonnaall hheeaavvyy cclleeaanniinngg uussee,, aa cclleeaanneerr ssuucchh aass
LLiiqquuiid
d ZZuudd ccaann bbee uusseedd aaccccoorrddiinngg ttoo ppaacckkaaggee ddiirreeccttiioonnss.. DDoo nnoott
ppeerrmmiitt cciittrruuss oorr ttoommaattoo jjuuiiccee ttoo rreemmaaiinn oon
n ssttaaiinnlleessss sstteeeell ssuurrffaaccee,, aass
cciittrriicc aacciidd wwiillll ppeerrmmaanneennttllyy ddiissccoolloorr ssttaaiinnlleessss sstteeeell.. WWiippee uupp aannyy ssppi
illllss
iimmmmeeddiiaatteellyy..
BBrraassss PPaarrttss
CCAAUUTTIIOONN::
All brass special ordered parts are coated with an epoxy
coating.
DDOO NNOOTT UUSSEE BBRRAASSSS OORR AABBRRAASSIIVVEE CCLLEEAANNEERRSS OONN TTHHEE
BBRRAASSSS OOPPTTIIOONN PPAARRTTSS..
All brass parts should be wiped regularly with
hot soapy water.
OOvveenn RRaacckkss
Clean with detergent and hot water. Stubborn spots can be scoured
with a soap-filled steel wool pad.
RReeppllaacciinngg tthhee bbaatttteerryy ((ccaarrtt mmooddeellss))
Each cart model is equipped with a battery for the electronic ignition.
To replace the battery:
1. Locate the access door on the back left rear side of the cart.
2. Remove the two screws located at the bottom of the access door.
3. Locate the round black cap behind the access panel.
4. Unscrew cap. Battery is snapped in the cap.
5. Snap cap on battery and screw back into slot inside cart.
Access Door
Screws
Battery cap
9-volt Battery