Viking VCCM12MS Coffeemaker User Manual


 
10
Note: If icons continue to blink, the parts are not properly installed and must be removed and properly
replaced before brewing begins.
ProgramHour Display/Clock Display
Minute Display/Cup Select 4-12
On/Off
Brew
Program Icon
Icon is lit when PROG time
is shown for setting program
time
Water Reservoir Icon
On: Water is heating
Flashing: Water reservoir
is not filled, properly installed,
or unit may need to be descaled
Brew Icon
On: Coffee Maker is now brewing
Clock and Program Time
Cup Select Icon
Number of cups to be
brewed (4-12 Cups)
Brew Basket Icon
Flashing: Brew basket is not
properly installed
Bell Icon
Unit is programmed to brew at set time
Setting the programmed time
Press the PROG (Program) button once until the PROG display appears.•
Press the CUPS button until the desired number of cups is reached.•
Press the PROG button once until the Bell icon • is displayed.
Press Hour (H) or Minute (M) button to set the desired program time. If buttons •
are held down this will cause fast advance of hour and minute display.
Press the PROG button again, bell icon on and PROG icon off. Hour and •
Minute display will go back to clock display.
The Bell icon will be displayed to indicate program mode has been •
activated.
When this time is reached, the heater will heat the water, the pump will start •
to cycle, and brewing automatically begins at the designated time.
To discontinue the program feature, simply press the PROG button until the •
Bell icon disappears.
The clock program time must be reprogrammed after power is lost, due to a •
power outage, or being unplugged.