Filter
Top Products
14
Cleaning and Maintenance
Cleaning Hood Canopy
Finishes in enamel or stainless steel are highly resistant to
damage or discoloration due to grease, steam, and heat—
provided that reasonable care is given to the equipment. The
following suggestions will help keep your hood looking new.
1. Do not allow an excessive accumulation of grease. For best
results, you should wipe your hood clean with a cloth dipped in
warm, soapy water. DO NOT USE ABRASIVE CLEANSERS,
STEEL WOOL PADS, OR ABRASIVE CLOTHS. DO NOT use
cleansers that contain chlorides; the chlorides in the cleaner
could damage the stainless steel finish. If you need to scrape
stainless steel to remove encrusted materials, first soak the area
with hot towels to loosen the material, then use a wooden or
nylon spatula or scraper. DO NOT use a metal knife, spatula, or
any other metal tool to scrape stainless steel.
2. Every 3 months give your hood a thorough cleaning. On
painted surfaces, use a new coat of wax. A good wax
cleaner—available at either a grocery or hardware store—will
do both jobs at once. On stainless steel surfaces, use a good
stainless steel cleaner and polish.
Renewing Enamel Finish
If discoloration occurs, you should thoroughly polish the finish
on your hood to renew its gloss and luster and to remove any
grease residue which may have a yellowing effect. Use any
good enamel polish, refrigerator polish, or automotive polish.
Renewing Stainless Steel Finish
Regular cleaning is the best way to assure that your stainless
steel finish stays bright and unscratched. Use lemon oil or
stainless steel polish to coat and protect stainless steel.
CAUTION
Do not use a porcelain cleaner or rough abrasive cleaner.
15
Cleaning Brass Parts
All brass body parts should be wiped regularly with hot soapy
water. When hot soapy water will not do the job, use every day
household cleaners that are not abrasive.
Cleaning Ductless Venting Chamber
(Professional Hoods Only)
1. Remove the middle vent by gently raising up and pulling
out.
2. Use the same cleaning directions as in “Cleaning the Hood
Canopy” section.
3. After cleaning, replace the middle vent.
Replacing the Light Bulbs
When removing bulbs use an oven mitt to protect your hand
in case the bulb breaks.
Halogen Lights
1. Unscrew halogen bulb.
2. Replace the bulb with a 120 volt, 50-watt halogen bulb.
Infrared Heat Lamp
1. Unscrew infrared bulb from heat lamp socket.
2. Replace the bulb with an R40, 120 volt, 250-watt infrared
bulb.
Cleaning and Maintenance
CAUTION
All brass special ordered parts are coated with an epoxy
coating. DO NOT use brass cleaners or abrasive cleansers
on the brass option parts.
Product Care
Product Care