Filter
Top Products
5756
Product Care
Product Care
Replacing Light
PROBLEM POSSIBLE CAUSE AND/OR REMEDY
1. Oven will not function. Oven is not connected to electrical power.
Have electrician check power circuit breaker,
wiring and fuses.
2. Oven does not Door is not shut tight enough for
operate in self-clean mode. automatic door latch to lock.
3. Door will not open. Oven is still in Self-Clean Mode. If oven is
hot, door latch will release when a safe
temperature is reached.
4. Oven light will not work. Light bulb is burned out.
Oven is not connected to power.
Trouble Shooting
Error Message Problem Correction
MODEL ERROR
An incorrect
model numberhas
been installed.
Call your Viking dealer or
authorized service agency.
RTD ERROR
RTD is open or
shorted.
Call your Viking dealer or
authorized service agency.
PROBE ERROR The meat
probe is open
or shorted.
The meat probe may not be
plugged in. If it isn't, plug it in to
the oven. Press the OFF key to
exit and clear the error message.
If the meat probe is plugged
in and the Error message is still
displayed, call your Viking dealer
or authorized service agency.
LATCH ERROR
The control is
unable to lock
or unlock the
door latch.
Call your Viking dealer or
authorized service agency.
KEYBOARD
ERROR
No connection
exists between
the keyboard
and control.
Call your Viking dealer or
authorized service agency.
Error Handling
In the event that you make an error while programming your Viking oven,
you will hear a long beep followed by the appearance of an error message
on the display. Use the following key to help you correct these common
programming errors:
Replacing Interior Halogen Oven Lights
Do not touch bulb with bare hands. Clean off any signs of oil
from the bulb and handle with a soft cloth.
Power Failure
Do not attempt to use during a power failure. Unit will not
function.
CAUTION
DISCONNECT THE ELECTRIC POWER AT THE MAIN FUSE OR
CIRCUIT BREAKER BEFORE REPLACING BULB.
1. Unsnap glass light cover
using a screwdriver in the
access groove.
2. Firmly grasp light bulb and
pull out.
3. Replace with halogen bulb
using volt and wattage
requirements listed on glass
cover.
4. Replace the light cover by
snapping glass cover onto
metal box.
5. Reconnect power at the main
fuse or circuit breaker.
access
groove
light
bulb
glass light
cover