Viking VESO1272SS Oven User Manual


 
4
3
• Do not heat unopened food containers; buildup of pressure
may cause the container to explode and result in injury.
• Always position oven racks in desired location while oven is
cool. If rack must be moved while oven is hot, do not let
potholder contact hot heating element in oven.
• Use care when opening oven door. Let hot air or steam escape
before removing or replacing food. Hot air or steam can cause
burns to hands, face and/or eyes.
• Keep oven vents unobstructed. The oven vent is located at the
front of the oven and vents into the room.
• Do not clean door gasket. It is essential for a good tight seal.
Care should be taken not to rub, damage, or move the gasket.
No commercial oven cleaner or oven liner protective coating
such as aluminum foil should be used in or around any part of
the oven. Improper oven liners may result in a risk of electric
shock or fire. Keep oven free from grease buildup.
• Before self-cleaning the oven, remove broiler pan, broiler grid,
oven racks, and other utensils. Do not use your oven to clean
other parts. A fan noise should be heard during the cleaning
cycle. If not, call service before self-cleaning again.
• DO NOT TOUCH HEATING ELEMENTS OR INTERIOR
SURFACES OF OVEN. Heating elements may be hot even
though they are dark in color. Interior surfaces of an oven
become hot enough to cause burns. During and after use, do
not touch or let clothing or other flammable materials contact
heating elements or interior surfaces of oven until they have had
sufficient time to cool. Other surfaces of the oven may become
hot enough to cause burns, such as the oven vent opening, the
surface near the vent opening, and the oven door window.
SAVE THESE INSTRUCTIONS
Getting Started
Getting Started
*NOTE: The PROBE function is included on Premiere Models.
Digital Display
The time-of-day must be set before
any other program can be used.
When your oven is first connected to
the power in your home, the timer
display will show --:--.
To program the time-of-day:
1. Press the “CLOCK/PROBE”* button once. 12:00 will be
displayed with the word SET in the upper right corner.
2. Turn the “SET” knob until the correct time-of-day is displayed.
AM and PM are not indicated.
3. Press the “CLOCK/PROBE” button again. The word SET will
disappear and the correct time is now set into the timer.
The time-of-day can be changed by following steps 1 through 3.
It cannot be changed while there is a Bake Hours or Start Time
cycle programmed into the timer.
Analog Display
(Designer Timepiece Models)
The time-of-day must be set before any
other program can be used. When your
oven is first connected to the power in
your home, the digital display will show
00:00.
To program the time-of-day:
1. Push and hold the “timer” and “bake
hours” buttons at the same time.
2. Turn the “Set” knob until correct time is displayed on the
digital clock.
3. Release “timer” and “bake hours” buttons.
The analog clock will automatically set after the digital time is set.
bake
hours
timer
start
time
probe
temp
Set
SET
B
AKE
H
OURS
M
IN/SEC
T
IMER
S
TART
T
IME
C
LOCK/
P
ROBE
SET
Important Safety Instructions
Setting the Clock