Vinotemp VT - PONYKEG Beverage Dispenser User Manual


 
17
17621 South Susana Road, Rancho Dominguez, California 90221
info@vinotemp.com
BEER DISPENSER TROUBLESHOOTING GUIDE
You can solve many common problems easily, saving you the cost of a possible service call.
Try the suggestion below to see if you can solve the problem before contacting Vinotemp
at info@vinotemp.com.
PROBLEM POSSIBLE CAUSE
Beer dispenser does not
operate
Not plugged in.
Circuit breaker tripped or a blown fuse.
The temperature control knob is set in “OFF” position.
Turns on and off frequently Room temperature is hotter than normal.
Appliance door is open too often.
Door is not closed completely.
Temperature control is not set correctly.
Door gasket does not seal properly.
Beer dispenser does not have the correct clearances.
Vibrations Check to assure that the beer dispenser is leveled.
Beer Dispenser seems to
make too much noise
Rattling noise may come from the flow of the
refrigerant; this is normal.
As each cycle ends, you may hear gurgling sounds
caused by the flow of refrigerant in your beer
dispenser.
Contraction and expansion of the inside walls may
cause popping and crackling noises.
Beer dispenser is not leveled properly.
Door will not close properly
Beer dispenser is not leveled.
Door was reversed and not properly installed.
Door gasket is dirty.
The shelves, metal plate, or beer keg are out of proper
position.
TECHNICAL SPECIFICATIONS
Model No.
V
V
T
T
-
-
F
F
U
U
L
L
L
L
K
K
E
E
G
G
Power 115V/60Hz
Rated Current 1.4A
Power Input 115W
Power Consumption .09 kW.h/24h
Refrigerant R134a/3 oz
Size (W x D x H) 20.1" x 24.8" x 33.7"