Filter
Top Products
- 2 -
Fig. 2.2 TOP EXHAUST GASKET
• Cut a rectangular opening with the ¼” clearance at the rear of wine
cabinet to the width and height of the cooling unit.
• If top exhaust, cut a rectangular opening at the top of the cabinet to the
length and width of the top exhaust openings.
• Mount the gaskets on the four mounting sides.
• If top exhaust, place the gaskets along the top openings at the top of the
cooling unit.
• Place the cooling unit to a flat and stable place.
• Then move it on the top of the rack temporally.
• Move the cooling unit towards the mounting sides and push to compress
the gasket.
• Locate the 3 brackets (6) and use 7/16” wrench to tighten the 3 screws (7).
• Screw the exhaust and fresh air grille on the opening from the rear side of
the cabinet.
• If top exhaust, install the top exhaust grille at the top of the cabinet.
• Plug the cooling unit in receptacle.
• Screw the 2 screws (4) and locate the light on the ceiling.
• Plug the light in receptacle.
• Plug the wine cabinet.
3. Electrical Cord
• We strongly recommend against the use of an extension cord. However, if
you still select to use an extension cord, it is absolutely necessary that it is
a UL LISTED 3-wire grounding type appliance extension cord. The
marked rating of the extension cord should be 115 V, 15 A. or equivalent
and not greater than 15ft in length.