Filter
Top Products
11
English10 English
How to Clean
Your Tower Circulator has no user
serviceable parts. Do not disassemble
the unit. This will void your warranty. If
service is required, return your circulator
to Vornado (see WARRANTY for
instructions on page 12).
The motor is permanently lubricated
and requires no oiling.
Because your Tower Circulator moves a substantial amount of air, it
will need regular cleaning. To clean follow these simple instructions:
1. Unplug the unit.
Note: Do not use gasoline, thinners, solvents or other
chemicals for cleaning
.
2. Use the brush attachment on your household vacuum
cleaner to vacuum any accumulated dust off the Front
Angled Outlet Grill and Side Inlet Grill. Wipe down the
entire surface with a soft cloth.
Storage
It is recommended to store your Tower Circulator by following these
instructions:
1. Unplug power cord and bundle loosely.
2. Thoroughly clean your Tower Circulator (see instructions above).
3. Cover, or place back in retail carton if available. This will prevent
the unit from accumulating dust overtime.
4. Store unit in a cool and dry location.
Getting the Most From Your Circulator
Thank you for your purchase. It’s important for you to know that this
product functions very differently than typical tower fans you may
have used in the past. Here are a few things to keep in mind:
Expect Powerful Circulation
Your Tower Circulator is designed to move considerably more air than
a traditional tower fan. Consider the following as you adjust product
settings.
Operating Tips
Ultra-high volume airflow. Increased sound lev-
els may be perceptible due to airflow volume
and velocity.
High volume airflow. Rapidly moves air across
the room for efficient cooling. Increased sound
levels may be perceptible due to airflow volume
and velocity.
Superior circulation power compared to tradi-
tional tower fans on their high setting. May be
preferred for day-to-day use.
Near-silent operation while offering steady cir-
culation.
Turbo Setting
High Setting
Middle Setting(s)
Low Setting
Cleaning and Storage Troubleshooting
Unit is not plugged in. Plug Power Cord into electrical outlet.
Unit is damaged or in need of repair. Cease usage and unplug. Contact Consumer Service for assistance.
Fuse needs to be replaced. See IMPORTANT INSTRUCTIONS for how to replace the fuse or contact Consumer Service.
Ensure unit is set to highest setting for maximum air circulation.
Allow the unit to fully circulate the air throughout the room, this may take several minutes.
Ensure all air inlets and outlet grill are unobstructed.
The battery is packaged separately and may not be installed. Refer to CONTROLS - Remote Control Battery on page 9
for instructions.
The battery is dead. Replace with new 3 volt CR2032 battery. Refer to CONTROLS - Remote Control Battery on page 9
for instructions.
The remote requires a line-of-sight path to allow for the signal to be received by the unit. Position the unit so the
receiver lens (located above the Vornado logo) is visible from the remote control.
Unit fails to
power on.
Unit is not pro-
ducing sufficient
amount of air.
Remote Control
is not working.
Problem Possible Cause and Solution
View cleaning tutorial
on your mobile device.