Filter
Top Products
– 2 –
HEATER (Fig. 1)
1. Push one end of the heater into one socket as far as it will go.
2. Swing the other end of heater up until it lines up with the opposite socket.
3. Release heater and it will snap into place.
4. Grasp the heater and move it back and forth to ensure that it is centered correctly.
5. Rotate the heater clockwise, then counterclockwise, to ensure that it is seated correctly.
COOLING FANS
1. Remove the access panel on the left side of the cheesemelter.
2. Unscrew the four mounting screws.
3. Disconnect the fan leads and lift out the fan.
4. Install new fan.
• Make sure that all wires are enclosed by the nylon wire clamps so that none of the wires
can reach the fan blades.
The cooling fan should blow air into the control compartment. An arrow on the fan housing indicates
the direction of air flow.
PL-53526-E
Fig. 1
WARNING: DISCONNECT THE ELECTRICAL POWER TO THE MACHINE AND
FOLLOW THE LOCKOUT / TAGOUT PROCEDURES.
PARTS REPLACEMENT