Filter
Top Products
GBD_GBDF SERIES GAS FRYERS
VULCAN-HART F-32934 Rev. B (June 2008)
-9-
When installing a quick disconnect you must also install a means for limiting the
movement of the fryer. This device will prevent the gas line or quick disconnect
from being strained. The restraining device should be attached to the cutout on the
back panel. See illustration for location.
In Australia, use only the caster supplied by the manufacturer for the fryer
device. The fryer must be installed using a hose assembly restraining device to
limit the movement of the appliance in accordance with AS1869.
The fryer must be installed with a connector (not supplied by Vulcan)
complying with the above codes.
The fryer must be installed with restraining means to guard against
transmission of strain to the connector. See illustration.
The fryer must be installed with the casters provided.
If the restraint is ever to be disconnected, first turn the gas supply off.
ELECTRICAL CONNECTION
The fryer comes with a NEMA 15-5P plug that requires 120 Volt service. Plug in the
wire connection into an approved outlet.