Filter
Top Products
GRM SERIES GAS FRYERS
VULCAN-HART F-31233 Rev. K (February 2011)
-4-
INTRODUCTION
GENERAL
Vulcan Fryers are produced with quality workmanship and material. Proper installation,
usage and maintenance will result in years of satisfactory performance.
Before installing the fryer, thoroughly read this manual and carefully follow all instruction.
This manual is applicable to model listed on the cover page. Procedures in this manual
will apply to all models unless specified. Pictures and illustrations can be of any model
unless the picture or illustration needs to be model specific.
ORDERING PARTS
Customers may order parts directly from their local authorized service center. If not
known, call Vulcan Customer Service at 800-814-7028.
To speed up your order, provide the model number, serial number, gas type, part needed,
item part number (if known) and quantity needed.
FRYER CAPACITY
MODEL -
GMO
# of Heat Tubes
Each Fry Tank
BTU / Hour
Each Fry Tank
Width Inch (cm)
Total System
Shortening lbs. (kg)
Each Fry Tank
1GR35M 3 90,000 15.5" (39) 35-40 (16-18)
1GR45M (F) 4 120,000 15.5" (39) 45-50 (21-23)
1GR65M (F) 5 150,000 21.0" (53) 65-70 (29-32)
1GR85M (F) 5 150,000 21.0" (53) 85-90 (39-41)
2GR45MF 4 120,000 31.0" (79) 45-50 (21-23)
3GR45MF 4 120,000 46.5" (118) 45-50 (21-23)
4GR45MF 4 120,000 62.0" (158) 45-50 (21-23)
2GR65MF 5 150,000 42.0" (107) 65-70 (29-32)
3GR65MF 5 150,000 63.0" (160) 65-70 (29-32)
2GR85MF 5 150,000 42.0" (107) 85-90 (39-41)
3GR85MF 5 150,000 63.0" (160) 85-90 (39-41)
UNPACKING
This fryer was carefully inspected before leaving the factory. Upon acceptance of the
shipment, the transportation company assumes full responsibility for safe delivery.
Immediately after unpacking the fryer, check for possible shipping damage. If the fryer is
damaged, save the packaging material and contact the carrier within 15 days of delivery.