Filter
Top Products
-
16 -
2. Reach through the back of the unit. Squeeze the burner retaining clip and slide off burner
retaining pin.
3. Lift the burner up so the retaining pin clears the corresponding hole in the chassis, then pull
the burner out through the back of the unit.
4. Replace by inserting the burner through the rear of the unit and engaging the burner venturi
onto the burner orifice at the front of the unit.
5. Seat the retaining pin in the hole in the chassis and attach the retaining clip.
6. Remove the control panel to check that the venturi is properly fitted over the orifice.
7. Reassemble the control and back panels, then check for proper operation.
BURNER ADJUSTMENT
For efficient burner operation, it is important that a proper balance of gas volume and primary air
supply is maintained to give complete combustion. Insufficient air supply results in a yellow streaming
flame. Primary air supply is controlled by the air shutter on the front of the burner venturi. Loosen the
screw on the venturi and adjust the air shutter to just eliminate yellow tips on the burner flames. Lock
the air shutter in place in place by tightening the screw. Repeat this procedure as necessary with all
burners.
MAIN BURNERS
These photos are for reference – it should not be necessary to remove the griddle top to perform the
procedures listed in this manual.
FLASH TUBE
BURNER CLIP
(U
NDERNEATH
)
PILOT ASSY
IGNITION PORTS
ORIFICE
AIR SHUTTER