Vulcan-Hart 3GR45MF Fryer User Manual


 
GRM SERIES GAS FRYERS
VULCAN-HART F-31233 Rev. F (January 2008)
-21-
4. Drain the oil out of the fry tank by turning the red handle drain valve. The filter pan will begin
to fill with oil. When the oil level fills half of the filter pan, pull the red handled filter lever
towards you. The motor / pump will begin and oil will flow back into the fry tank. The oil will
flow into the back of the tank towards the front and down the drain back into the filter pan.
Use the provided filter brush to help wash down the residue from the bottom and sides of the
fry tank and allow it to flow down into the filter pan.
5. Close the red handle drain valve turning off the flow of oil into the filter pan. The fry tank will
begin to fill. It is normal to see air bubbles in the tank towards the end of filtering. The motor
/ pump sound will change when the filter pan is empty of oil. Push in the red filter handle
lever and turn the power switch OFF.
6. The oil level is correct when it is between the Min / Max lines on the fry tank.
7. Turn the Thermostat knob to the desired temperature. Burners should turn on and the oil
should begin to heat.
8. Repeat this procedure for the remaining tank(s) in the battery.
9. When finished filtering, clean all of the filter components as in step 1 under Assembly
section.
FILTERING TIP:
Open the filtering drawer approximately 1” to allow any oil in the return line to run back into the filter
pan. This will take about 30 seconds to complete. Then open the drawer completely to clean filter
components.
REMOVING EXCESS DEBRIS FROM THE FILTER:
1. Pull the filter drawer out and remove the crumb basket and empty any debris into the trash.
2. Remove the filter screen assembly. Scrape debris from the filter screen. Then remove the
insert by unlatching the latch. Clean all parts thoroughly as mentioned in the Assembly
section on page 17.
3. Scrape debris from the bottom of the filter pan and discard in the trash. Clean all parts
thoroughly as mentioned in the Assembly section on page 17. Clean all parts thoroughly as
mentioned in the Assembly section on page 17.
4. Reassemble all filter components after being dried thoroughly as in the Assembly section on
page 17.