Vulcan-Hart 72SC Range User Manual


 
Fig. 57
4. Remove manifold cover.
Fig. 58
5. Remove compression nut from pilot valve then
remove pilot tube assembly from valve.
Fig. 59
6. Remove pilot tube assembly from pilot bracket.
Use pliers to separate as needed.
Fig. 60
7. Reverse procedure to install.
NOTE: If replacing pilot and tubing, ensure a
compression nut and ferrule are installed on the end
of tubing that connects to pilot valve.
ENDURANCE / CHALLENGER MODULAR SERIES GAS RANGES - REMOVAL AND REPLACEMENT OF PARTS
F45471 Rev. A (0615) Page 26 of 38