Filter
Top Products
— 4 —
ASSEMBLY
Legs
Place the griddle on its back. Screw the legs into the permanently fastened nuts on the four corners of the griddle.
Hand-tighten the legs.
Set the griddle in its installation location. Turn the adjustment screw at the bottom of each leg to level the griddle plate.
Stand (Fig. 1)
1. Start external threaded end of leg extension into griddle frame.
2. On stands 72" or wider, attach undershelf brace to undershelf with
1
/4-20 x
1
/2 nut.
3. Start threaded end of adjustable leg through undershelf into internal threaded end of leg extension.
4. Tighten both leg extension and adjustable legs.
5. If casters are furnished instead of adjustable legs, the locking swivel casters must be placed in the front.
INSTALLATION CODES AND STANDARDS
Your Vulcan griddle should be installed in accordance with state and local codes, or in the absence of local codes,
with National Fuel Gas Code ANSI-Z223.1 (latest edition), available from the American Gas Association, Inc., 1515
Wilson Blvd., Arlington, VA 22209, and National Electrical Code ANSI/NFPA 70 (latest edition).
In Canada, installation should be in accordance with local codes, or in the absence of local codes, with Canadian
Standard CAN/CGA-B149.1 NATURAL GAS (latest edition), or CAN/CGA-B149.2 PROPANE GAS (latest edition)
available from the Canadian Gas Association, 55 Scarsdale Road, Don Mills, Ontario, Canada M3B2R3, and
Canadian Electrical Code Part 1 CSA-C22.1 (latest edition).
▼
▼
▼
PL-40556
Fig. 1