Vulcan-Hart 936A ML-52596 Griddle User Manual


 
— 7 —
PL-40557-1
Red Reset Button
Fig. 2
4. When gas at pilot has been burning for about 45 seconds, release the red button. If pilot does not remain lit, repeat
the operation, allowing more time before releasing red reset button.
Operating a Standard Griddle
Turn the thermostat to the desired setting. Since all burners are lit from constantly burning pilots, this is all that is
required to put the griddle into service.
For the griddle plate, turn burners on about 15-20 minutes before cooking for preheating. Set the thermostat dials.
Each thermostat will control gas flow to burners to bring that area of the plate up to the set temperature.
Extended Shutdown
1. Turn manual shutoff valve to OFF.
2. Turn all control knobs to the OFF position.
3. Shut off the pilot flame by turning the adjusting screw on the pilot valve.
4. Turn off electric supply to the griddle.
If the griddle is to be shut down for an extended period, put a heavy coat of grease over the griddle plate to prevent
rusting.
GRIDDLES WITH ELECTRIC IGNITION
Lighting the Pilot
NOTE: In case of power failure, do not attempt to operate the griddle.
CAUTION: Do not turn on the electric supply without first making sure that gas is flowing to the pilots. Failure
to do this may shorten the life of the electric ignition igniter.