Vulcan-Hart C24EA3 480V BASIC Electric Steamer User Manual


 
MODEL C24EA - SWITCHES, BUZZER AND SOLENOIDS
F25213 (May 2006)Page 29 of 52
3. Push handle fully in and keep in position.
4. Position plunger of on/off switch against linkage
bracket such that plunger is fully engaged.
A. Adjust switch such that switch plunger is
perpendicular with linkage bracket when
handle is pushed in fully.
B. Tighten switch mounting screws.
Professional Models
1. Remove the RIGHT SIDE PANEL.
2. Locate the on/off switch mounted to the front
panel.
3. Disconnect electrical plug from switch.
4. Remove switch from front panel.
5. Reassemble parts removed in reverse order.
DOOR SWITCH
WARNING: DISCONNECT THE
ELECTRICAL POWER TO THE
MACHINE AND FOLLOW LOCKOUT /
TAGOUT PROCEDURES.
Removal
1. Remove the RIGHT SIDE PANEL.
2. Open cooking compartment door.
3. Note wiring connections and disconnect
electrical wiring from switch.
4. Remove switch from door switch mounting
bracket. Retain hardware.
Installation
1. Verify E-clip is installed on door switch linkage
in groove nearest front panel (if two grooves in
linkage are present).
2. Loosely install door switch onto door switch
mounting bracket.