Filter
Top Products
-
4 -
ASSEMBLY — Legs (optional)
If using legs, four legs are required on 24, 36, and 48" models; six legs are required on 60 and 72"
models. Assemble legs to the bottom of the unit through threaded holes in the four corners of the unit;
on 60 and 72" models, the extra two legs mount at the middle of the front and back rails.
ASSEMBLY — Wall Mounting Brackets (optional)
If mounting the Cheese Melter on a wall: Attach the wall mounting bracket(s) to the wall with suitable
fasteners (not supplied with the kit); hang the Cheese Melter from its angle iron rail on the wall
mounting bracket(s) (Fig. 1).
INSTALLATION CODES AND STANDARDS
The Cheesemelter must be installed in accordance with:
In the United States of America:
1. State and local codes.
2. National Fuel Gas Code, ANSI-Z223.1/NFPA #54 (latest edition). This shall include but
not be limited to: NFPA #54 Section 10.3.5.2 for Venting. Copies may be obtained
from The American Gas Association Accredited Standards Committee Z223, @ 400
N. Capital St. NW, Washington, DC 20001 or the Secretary Standards Council, NFPA,
1 Batterymarch Park Quincy, MA 02169-7471
NOTE: In the Commonwealth of Massachusetts
All gas appliances vented through a ventilation hood or exhaust system equipped with
a damper or with a power means of exhaust shall comply with 248 CMR.
3. NFPA Standard # 96 Vapor Removal from Cooking Equipment, latest edition, available
from the National Fire Protection Association, Batterymarch Park, Quincy, MA 02269.
In Canada:
1. Local codes.
2. CAN/CSA-B149.1 Natural Gas Installation (latest edition)
3. CAN/CSA-B149.2 Propane Installation Code (latest edition), available from the
Canadian Gas Association, 178 Rexdale Blvd., Etobicoke, Ontario, Canada M9W 1R3
Angle Iron on Rear of
Cheese Melter Frame
Wall Mounting Brackets
Fig. 1