Filter
Top Products
Fig. 14
NOTE: If liquid drained from kettle is still clean, save
for reuse.
5. Remove CONTROL BOX COVER.
6. Note lead wire locations and disconnect wires
from heating element.
7. Remove mounting nuts securing heating element
to kettle.
Fig. 15
8. Remove heating element from kettle.
9. Reverse procedure to install. Use a new heating
element seal whenever installing heating
element. Torque mounting bolts to 40 ft-lbs and
tighten in an alternating pattern.
10. Refill jacket with fluid. See FILLING THE
RESERVOIR JACKET.
11. Remove air from reservoir jacket as outlined
under VENTING.
12. Check for proper operation and leaks around
heating element.
WATER LEVEL PROBE (LLCO)
Disconnect the
electrical power to the machine and
follow lockout / tagout procedures.
1. Open pressure relief valve until reservoir jacket
is completely vented.
2. Remove BOTTOM COVER.
3. Disconnect lead wires from the water level
probe .
Fig. 16
4. Place a large container under kettle to catch
liquid that drains from kettle.
NOTE: If liquid drained from kettle is still clean, save
for reuse.
5. Remove component from bottom of kettle.
6. Reverse procedure to install.
NOTE: Clean threads and apply pipe thread sealant
when replacing water level probe.
7. Refill jacket with fluid. See FILLING THE
RESERVOIR JACKET.
8. Remove air from reservoir jacket as outlined
under VENTING.
Electric Stationary and Tilting Kettles - REMOVAL AND REPLACEMENT OF PARTS
Page 9 of 29 F45472 (1112)