Vulcan-Hart ML-044962 Oven User Manual


 
17
Snorkel Oven and/or Electric Ignition Oven with KX Thermostat
1. Place the instrument sensor or thermometer in the center of the oven cavity and close the door.
2. Turn fan switch on. Set temperature dial to 300°F. Allow oven to cycle at least five times (approximately
15 minutes). If the temperature is more than 15°F different from the dial setting, calibrate as follows.
A. Pull the dial straight off. Turn the calibration screw (Diagram #10) clockwise to decrease temperature
or counterclockwise to increase temperature (
1
/4 turn equals approximately 35°F).
B. Replace dial and increase temperature 50°F. Allow oven to cycle at least three times and recheck the
temperature.
C. If the temperature is more than 15°F different from the dial setting, the thermostat may need to be
replaced.