Vulcan-Hart VPX3 Oven User Manual


 
– 9 –
Using The Timer
When the TIMED mode is selected, the steamer comes up to idle temperature (lower than the
cooking temperature). The operator then selects the desired time with the TIMER control. This
quickly brings the steamer up to cooking temperature. At the end of the timed cycle, the steamer
returns to the idle temperature.
The steamer takes approximately 10 minutes to warm up before cooking can begin. The HEATER
LIGHT turns off when the steamer is ready.
OPERATING THE STEAMER
Close the drain valve.
• Open the door and pour water into the cooking compartment up to the water level mark.
The water level mark is visible on the back wall of the steamer).
• Select TIMED or CONTINUOUS on the COOKING MODE switch.
• Close door and wait approximately 10 minutes for the HEATER LIGHT to go off. This
indicates the steamer is ready.
SHUTDOWN
• Turn COOKING MODE switch to OFF.
• Allow the steamer to cool.
• Open the drain valve and drain the water from the steamer.
• Open the compartment door to allow the inside to dry out.
• Follow the cleaning instructions in this manual.