Filter
Top Products
VCD SERIES CHIP WARMER F-38053 (09-10)
6
OPERATION
BEFORE FIRST USE
The Chip Warmer should be thoroughly
cleaned before initial use.
Always disconnect
electrical power to the Chip Warmer
before cleaning or servicing.
1. Remove Access Panel by
unlocking clips.
2. Place Access Panel away from
Chip Warmer.
3. Remove Top Door.
4. Remove all internal Baffles
through back opening.
5. Using a soft, clean cloth, clean
Top Door and Baffles with a
solution of mild detergent and
warm water. Rinse with a soft
cloth and warm water. Wipe dry
with a soft dry cloth.
Never spray the unit with a hose.
6. Using a soft, clean cloth, clean
the inside of the unit with a
solution of mild detergent and
warm water. Rinse with a soft
cloth and warm water. Wipe dry
with a soft dry cloth.
7. Replace Top Door and all internal
Baffles.
8. Reattach Access Panel.
TESTING THE CHIP WARMER
The Warmer and its
parts are hot. Be very careful when
operating, cleaning, or servicing the
warmer.
Before using the Chip Warmer for the
first time, verify that it operates properly.
1. Verify that the Chip Warmer is
connected to the correct power
source.
2. The Lighted Power Switch is
located on the top rear of the
Chip Warmer. Switch power
switch to ON position. Verify that
the switch illuminates. (Fig. 5)
(Fig.5)
3. Check the interior rear of warmer
to ensure that it is heating. The
internal thermostat is factory
preset to 180⁰ F. The blower fan
circulates heated air through the
perforated removable chip tray
located at the bottom of the
interior of the cabinet (under the
chips.)