Filter
Top Products
— 12 —
PL-41126-1
THUMB SCREWS
BAFFLE
Turning the Oven Off
Turn Power Switch to OFF.
Extended Shutdown
Turn Power Switch to OFF. Turn gas combination valve to OFF. Turn main gas shutoff valve to OFF.
USING THE OVEN
When power is applied to the oven, it will begin operating at the factory set temperature of 525°F
(273°C). The actual oven cavity temperature will appear in the temperature display and the Load
Indicator Light will indicate if the heat is on. To reset the set temperature, see SET POINT on page 9
or 10.
To read the temperature set point, press and hold the Read Set Point or Set Point button. The set point
will appear in the temperature display.
If the conveyor belt stalls, the time display will indicate "O.L." and the belt will automatically stop.
Remove the blockage and reset the control by moving the Belt Switch up and down. The time should
be indicated on the display again and the drive motor should restart.
On each end of the oven is a baffle (Fig. 6) which can be adjusted higher or lower to accommodate the
height of the product being cooked. To raise or lower the baffles, use insulated gloves and loosen the
two thumb screws (Fig. 6),
readjust baffle height, then retighten the two thumb screws.
Loading and Unloading the Oven
Place product in utensils (if required) and set utensils or products on the entrance end of the belt, but
not in the oven tunnel. Remove utensils or products from the oven after they completely clear the oven
tunnel.
Fig. 6