Waring HPB300 Blender User Manual


 
3
GROUNDING INSTRUCTIONS
For your protection, Waring
®
Blenders are equipped
with a 3-conductor cordset having a molded 3-prong
grounding-type plug, and should be used in combina-
tion with a properly connected grounding-type outlet as
shown in Figure 1. If a grounding-type outlet is not avail-
able, an adapter, shown in Figure 2, may be obtained
to enable a 2-slot wall outlet to be used with a 3-prong
plug. Referring to Figure 3, the adapter must be ground-
ed by attaching its grounding lug under the screw of the
outlet cover plate. CAUTION: Before using an adapter, it
must be determined that the outlet cover plate screw is
properly grounded. If in doubt, consult a licensed electri-
cian. Never use an adapter unless you are sure it is prop-
erly grounded.
Note: Use of an adapter is not permitted in Canada.
IMPORTANT: HOT BLENDING INSTRUCTIONS
To minimize possibility of scalding when blending hot
ingredients, the following precautions and procedures
must be observed:
1. Limit amount of material processed to 1½ cups
(12 oz.).
2. Completely remove the lid insert of the two piece
container lid before starting motor. (This will allow
venting of the rapidly heated and expanding air
present inside container when blender is running.)
3. Start blending on low speed.