Wells BT-4C Toaster User Manual


 
INSTALLATION
NOTE: DO NOT discard
the carton or other packing
materials until you have
inspected the appliance for
hidden damage and tested it
for proper operation.
Refer to SHIPPING DAMAGE
CLAIM PROCEDURE on the
inside front cover of this
manual.
DO NOT lift or carry the
toaster by the bread slots.
This will damage the
heating elements Lift and
carry by the carrying
handles only.
CAUTION:
Electric Shock
Hazard
The ground prong of the power
cord is part of a system
designed to protect you from
electric shock in the event of
internal damage to the
appliance.
NEVER CUT OFF THE
GROUND PRONG
(large round prong).
NEVER TWIST A PRONG TO
FIT AN EXISTING
RECEPTACLE.
If circuit or receptacle does not
match the toaster plug, contact
a licensed electrician to install
an electrical receptacle
appropriate to the voltage and
amperage requirements of the
toaster.
IMPORTANT:
Damage due to being plugged
into the wrong voltage or
phase is NOT covered by
warranty
UNPACKING & INSPECTION
Carefully remove the toaster from the carton. Remove all
protective plastic film, packing materials and accessories from the
toaster before plugging the toaster into electrical power or otherwise
performing any installation procedure.
Carefully read all instructions in this manual and the Installation
Instruction Sheet packed with the toaster before starting any
installation.
Read and understand all labels and diagrams attached to the
toaster.
Carefully account for all components and accessories before
discarding packing materials. Store all accessories in a convenient
place for later use.
SETUP
Setup the toaster only on a firm level surface. Non-combustible
material (e.g. metal, terrazzo) is recommended.
ELECTRICAL
Refer to the nameplate. Verify the electrical service power. Voltage
and phase must match the nameplate specifications. Plugging the
toaster into the wrong voltage can severely damage the equipment or
cause noticeably decreased performance.
Your appliance is equipped with a grounded electric power cord. This
cord must be plugged into a properly grounded electrical receptacle.
T-4C Toasters are equipped with a 4 foot cord with grounded NEMA
6-15P plug. This cord must be plugged into a 208 or 240 volt, 15 amp
circuit with a properly installed and grounded NEMA 6-15R
receptacle. Refer to toaster nameplate for proper voltage.
T-4C 15A Toasters and BT-4C Bagel Toasters are equipped with a 4
foot cord with grounded NEMA 5-15P plug. This cord must be plugged
into a 120 volt, 15 amp circuit with a properly installed and grounded
NEMA 5-15R receptacle.
4