Filter
Top Products
AGENCY LISTING INFORMATION
NOTE: DO NOT discard
the carton or other packing
materials until you have
inspected the appliance for
hidden damage and tested it
for proper operation.
Refer to SHIPPING DAMAGE
CLAIM PROCEDURE on the
inside front cover of this
manual.
IMPORTANT: This is a
GENERAL GUIDE.
For specific equipment and
cutout dimensions, and other
installation details, refer to the
Installation Instructions
supplied with the appliance.
IMPORTANT: Water damage
caused by failure to set
Wellsloks, failure to install
gasket, or failure to seal
flange to counter is NOT
covered by warranty.
UNPACKING & INSPECTION
Carefully remove the appliance from the carton. Remove all protective
plastic film, packing materials and accessories from the appliance
before connecting electrical power or otherwise performing any
installation procedure.
Carefully read all instructions in this manual and the Installation
Instruction Sheet packed with the appliance before starting any
installation.
Read and understand all attached labels and diagrams.
Carefully account for all components and accessories before discarding
packing materials. Store all accessories in a convenient place for later
use.
CUT-OUT AND INSTALLATION
Cutouts
a. Fryers may be installed in METAL COUNTERS ONLY.
b. Cutout dimensions for fryers and control panels are listed on
the Installation Instructions provided with the fryer.
c. Refer to the Installation Instructions for Underwriters
Laboratories Conditions of Acceptability.
Mounting the fryer:
a. Verify that provided sealants are applied to the under side of
the fryer top flange prior to setting the unit into the cutout.
b. After installation, verify that the tabs on the Wellsloks are
turned out to lock the appliance into the counter (see Fig. 2).
c. Apply a thin bead of food-grade silicone sealant around the
flange to seal it to the counter.
Refer to the Installation Instructions for required clearances. Maintain
required clearances between the appliance and adjacent combustible
and non-combustible surfaces.
Sufficient overhead clearance must be provided to allow the element
assembly to be raised. Refer to the Installation Instruction Sheet for
required clearances.
Avoid storing flammable or combustible materials near the appliance.
This includes gasoline and other fuels, mops, rags and wrapping paper.
This appliance conforms to NSF Standard 4 for sanitation only if
installed in accordance with the supplied Installation Instructions.
This appliance is Underwriters Laboratory recognized ( ). Since this
appliance is only a single component of a complete installation, the
finished installation of this unit requires additional evaluations to
Underwriters Laboratory standards.
Refer to Installation Instructions included with the appliance for
Underwriters Laboratories conditions of acceptability, electrical
requirements and other installation concerns.
4
INSTALLATION
STD 4
Fig. 2 Set the Wellslloks
M303 p/n 307590 OpManual Built-In Std Fryer