Filter
Top Products
TROUBLESHOOTING SUGGESTIONS
8
SYMPTOM POSSIBLE CAUSE SUGGESTED REMEDY
Circuit breaker off or tripped Reset circuit breaker
Unit not plugged in
Make sure unit is plugged in to
power receptacle
Warmer will not heat
Temperature control not set
Set control to desired
temperature
Internal damage
Contact you Authorized Wells
Service Agency for repairs
Warmer trips circuit breaker
Wet insulation Allow to dry or replace insulation
Pan leaking or other internal
damage
Contact your Authorized Wells
Service Agency for repairs
Internal damage
Contact your Authorized Wells
Service Agency for repairs
Warmer slow to heat
Mineral deposits on pan acting
as a insulator
Clean pan(s) with delime cleaner
Connected to wrong voltage
Verify supply voltage - must
match voltage on warmer
nameplate
Too much water
Remove water from pan until 1”
of water remains in pan
No power to warmer
002 p/n 303306 OpM CT Warmer_Inf. Sw.
There are no user-serviceable components in this appliance.
In all instances of damage or malfunction, contact your Authorized Wells Service Agency for repairs.