Filter
Top Products
4
A
SSEMBLING
Y
OUR
S
MOOTHIE
S
IGNATURE
™
II
Before assembling your Smoothie Signature
™
II wash all parts, except for the motor
base in warm, soapy water, rinse thoroughly and dry. Unscrew and disassemble the
valve for cleaning (see Cleaning Your Smoothie Signature
™
II section). To prolong
the life of your smoothie maker, do not wash parts in the dishwasher.
1. Position the rubber gasket down onto the circular flat surface in the blade base.
2. Screw the blade base onto the bottom of the blending jar by twisting the blade
base counter-clockwise until tightened. Make sure that the blade base is tightly
fastened to the blending jar and that the rubber gasket is properly compressed
between the blending jar and the blade base.
3. Press the lid on to the top of the blending jar. Place the clear lid cap in the
center of the lid or place the stir stick through the center of the lid if blending
liquids or frozen drinks.
4. Place the blending jar on to the motor base so the bottom of the blade base is
sitting flat on the motor base.
5. Plug in the cord. Your smoothie maker is now ready to use.
Stir Stick
Lid Cap
Lid
Blending Jar
Dispensing Valve
Rubber Gasket
Blade Base
Motor Base