West Bend MCD 289 Blender User Manual


 
2
IMPORTANT SAFEGUARDS
To prevent personal injury or property damage, read and follow all instructions
and warnings.
When using electrical appliances, basic safety precautions should always be
followed including the following:
Read all instructions, including these important safeguards and the care and use
instructions in this manual.
Do not use appliance for other than intended use.
The use of accessory attachments not recommended by Focus Electrics may
cause fire, electric shock or injury.
Do not operate if the blender is not working properly or if it has been damaged in
any manner. For service information see warranty page.
Do not leave unit unattended while plugged into an electrical outlet.
Keep hands and utensils out of the blending jar while blending to reduce the risk
of severe injury to persons or damage to the blender. A scraper may be used
but must be used only when the blender is unplugged and not in operation.
Do not attempt to repair this appliance yourself.
Blades are sharp. Use extreme caution during assembly, while operating,
disassembly and cleaning.
Do not use if blades are broken, cracked or loose.
Always operate blender with lid in place.
Always hold blending jar while processing for stability.
Do not leave blender unattended while it is operating.
Do not remove blending jar from base until the motor has stopped completely.
Do not use a cracked, chipped or broken blending jar.
When blending hot liquids, remove lid cap.
Avoid contacting moving parts.
To reduce the risk of injury, never place cutting assembly blades on motor base
without blending jar properly attached.
Do not use this appliance on the stovetop, under broiler, in the oven, in the
refrigerator or freezer.
To protect against electric shock, do not immerse cord, plugs, or other electric
parts in water or other liquids.
Do not operate any appliance with a damaged cord or plug.
Do not use this appliance outdoors.
Do not plug cord into wall outlet unless power switch is in “OFF” position.
Always turn control to “OFF” and unplug the appliance from outlet when not in
use, before cleaning. Allow to cool before putting on or taking off parts and
before cleaning.