Filter
Top Products
This section tells you how to make the most of the
refrigerator’s many useful features and how to clean them.
Both the refrigerator and freezer have door storage bins.
You can adjust the refrigerator bins to meet different storage
needs. All the door bins are completely removable for
cleaning. If you want to remove or adjust a bin, lift and tilt
to remove. To replace, fit top and push bin down until the
support lugs lock it in place.
You can use this compartment to store food and other items.
To operate lock, push up to open and down to lock.
You can use the crisper bin to store vegetables, fruits or
small goods. You can change the humidity inside the bin by
rotating the humidity control. You should store vegetables in
the crisper bin, but remember to set the humidity control to
more humid (vent closed).
You can also store fruits in the crisper bin, but remember to
set the humidity control to less humid (vent open).
The chiller allows you to store perishable food longer and
is useful for the fast chilling of food and drinks. However,
items may freeze if left near the vents. To prevent freezing,
move items away from the vents after chilling.
Your appliance is fitted with a catalysing deodoriser to
assist with the removal of the food odours inside your
refrigerator and freezer. Keeping food covered and
wrapping food with plastic wrap will also help to reduce
the odours inside your appliance.
1. Switch off the power at the power point and remove the
refrigerator’s power cord from the power point.
2. Remove shelves and chiller compartment.
3. Carefully unclip the light cover by pulling the top of the
cover towards you.
4. Unscrew the light bulb and replace it with a bulb that is
the same wattage and type as the original.
5. Replace the light cover.
6. Replace shelves and chiller compartment.
7. Wait 5 minutes to ensure pressure in the refrigeration
system are equalised. Then turn the refrigerator on at the
power point.
1. Switch off the power at the power point and remove the
refrigerator’s power cord from the power point.
2. Carefully unclip the light cover by pulling the top of the
cover towards you.
3. Unscrew the light bulb and replace it with a bulb that is
the same wattage and type as the original.
4. Replace the light cover.
5. Wait 5 minutes to ensure
pressure in the refrigeration
system are equalised.Then
turn the refrigerator on at
the power point.