Filter
Top Products
If local codes permit connection of the frame ground-
ing conductor to the neutral (white wire), connect the
green and white wire from the supply cable of the
appliance together and to the neutral (white) wire in
the junction box. Connect the remaining wires from
the supply cable. matching the colors, to the wires in
the junction box.
If local codes DO NOT permit frame grounding to the
neutral, separate the white and green wires that
extend out of the end of the supply cable of the
appliance. Connect the white wire from the supply
cable to the neutral wire In the junction box.
Connect the black and red wire from the supply cable.
matching the colors, to the corresponding wires in the
lunchon box. The green wire MUST now be used to
ground the appliance In accordance wtth local electri-
cal codes Connect the green ground wire to a
grounded cold water plpe*or to the grounded lead in
the service panel Do not ground to a gas supply pipe.
DC not connect to electrlcal power supply until
appliance
IS
permanently grounded. Connect the
ground wire before turning on the power See ffgure
2
COPPER
GROUNOEO COLD
WATER PIPE
GROUND WIRE
(REMOVE PAINT, ETC.)
GROUND CLAMP
(MUST BE TIGHT
ON PIPE)
FIGURE 2
*Cold water pipe must have metal continuity to electrical
ground and not be Interrupted by plastic, rubber or other
electrically insulating connectors (including water meter
or pcimp) without adding a jumper wire at these connec-
tions.
3.
INSTALLATION
NOTE:
Before installing the oven in the cutout, it may be helpful
to remove the oven door. See details below.
Insert appliance into cut-out. Screws are provided for
fastening the front frame of the appliance to the cabinet.
The mounting holes in the front frame of
appliance may be used as a template to locate the ap-
pliance mounting screw holes.
CAUTION: For your personal safety, and to minimize
potential personal injury, this oven must be securely
fastened to the cabinet, using the four screws that are
provided.
Use caution when mounting oven in cutout so you do
not overtighten screws and cause porcelain chippage
or puncture oven cavity.
TO REMOVE OVEN
View a
Open door fully.
View
b
Swing the 2 clips located on door in front of hinges so they
cross over the hinge slots (View a).
Close the oven door slowly until you feel it stop.
Lift up slightly allowing the bottom of the door to swing out.
(View b) Note that the top of the door must be tilted toward
the oven at this point to allow hing arms to swing free. if
appliance is so located that you cannot grasp both sides
of door you may grasp the door by handle (View c) and
follow same procedure outlined above.
TO REPLACE OVEN DOOR
CAU rlON - If connecting to a four-wire electrical system
(MOBILE HOME) the appliance frame MUST NOT be
connected to the neutral wire of the four-wire electrical
system. Separate the white and green wires that extend
out Jf the end of the supply cable of the appliance
Connect the white, red and black wires from the supply
cable, matching the colors, to the corresponding wires in
the IunctIon box. Connect the green wire from the supply
cable to the ground wire In the )unctlon box.
1. Grasp door by sides (View b) or by handle and align hinge
arms on door with TOP of slot in oven sides.
2. Tilt top of door toward the oven (View b) and allow door
to “ride” into position. A slight lifting and inward pressure
toward the bottom of the door will make sure it seats pro-
perly. (View d).
3. Open door fully and swing the clips away from the slots
(View a).