Filter
Top Products
Changing a cycle setting
(on some models)
You can change a cycle setting anytime
during any cycle.
1. Lift up the door latch to stop the cycle.
2. Turn the Cycle Control Knob clockwise to
the desired cycle.
3. Check the detergent dispensers. They
must be filled properly for the new cycle.
NOTE: Turning the Cycle Control Knob
can cause the covered section of the
detergent dispenser to open and release
the detergent. Check the covered section
if the cycle uses detergent in both
sections.
4. Close the door firmly until it latches. The
dishwasher starts the new cycle.
Adding an item during a cycle
(on some models)
You can add an additional item to the dish-
washer anytime before the Cycle Control
Knob reaches LIGHT WASH. Items added
after the Cycle Control Knob reaches LIGHT
WASH will only be rinsed.
1. Lift up the door latch to stop the cycle.
Wait for spraying action to stop before
opening the door.
2. Open the door and add the item.
3. Close the door, but do not latch it. Wait
30 seconds for the air in the dishwasher
to warm up. Doing so reduces the amount
of moisture in the vent when restarting a
cycle.
4. Close the door firmly until it latches. The
dishwasher resumes the cycle.
Using delay wash
(on some models)
You can set the dishwasher to start a cycle
1 or 2 hours later.
1. Push desired Cycle button.
gs
I
Ed
2. Push desired Option
button(s).
3. Turn Cycle Control Knob
clockwise to the number of
hours you want the dishwasher
to delay before the selected cycle starts.
4. Close and latch the door.
NOTE:
l You can add items while time is counting
down. Close and latch the door. The Cycle
Control Knob will not advance if the door
is unlatched.
l RINSE & HOLD and LIGHT WASH cycles
cannot be delayed.
14