Filter
Top Products
Install properly.. .
I. Allow ‘/” [ 2cm) space on each s’de and at top for
ease of ~nstallatlon
2 The refrigerator back can be flu+ against the wall
3 If the refrlgeratcr IS to be in a corner keep 1 : Inches
(3 1 cm) between the wall and s de of the re-
frlgerator so there IS room to cpen the SERVA-
DOOR’ or to clear the Ice and water dispenser
Level refrigerator-freezer.. .
Levelling Screw
“-4-w
Rlght to Raise.
Left to tower
1 Remove txxe grille (see page 101
2 To raise front, turn eacn scre:: ‘0 the rig-
3
To lower frcnt, ttirr each scrE-%6% to the left
4
Check with level
Remove sales labels.. .
Remove the Consumer Buy Guide label, tape and
any
inside
labels before Lsng the refrtgerator
To remove any remaining glue:
1 Rutz Driskli with thumb to make a ball then remove
OR
2 Sock area w#?h dIshwashing detergent solution (1
teaspoon detergert In 1 quart warrr water) before
removing glue as described in step 1
DO NOT USE rubbing alcohol or flammable or
toxic solvents, such as acetone, gasoline, car-
bon tetrachloride, etc. These can damage the
material.
NOTE: DO NOT REMOVE ANY PERMANENT IN-
STRUCTION LABELS INSIDE YOUR REFRIGERATOR.
Do not remove the Tech Sheet fastened under
the refrigerator at the front.
Clean-it.. .
%
-, ;- 1
Clean your refrigerator
kg=pG$J ~--I\
:d-
oefore ilslr’g I*
See cleonlng rlstructions -
on page 10
1-j
e
Plug it in...
Grounding Type
Wall Receptacle
Attachment
RECOMMENDED GROUNDING METHOD
A 230 Volt, 51: riz AC only, 7 5 ampere fused and
properly grounded electrIcal supp!y IS required It IS
recommenaea that a separate circuit serving only
this appliance be provided
Do not use an extension cord. Use a recepta-
cle which cannot be turned off with a switch or
pull chain.
See lndlvldual electrlcal requirements
and ground’pg nstructlor sheet In your literature
package