Filter
Top Products
Before Using Your
Refrigerator
I
In This Section
Page
Page
I
Cleaning
it .......................................... .5
Installing it properly
.......................... .6
Plugging
it in.. .................................... .5 Leveling it
............................................
6
It is important to prepare your refrigerator for use. This section tells you how to clean it,
connect it to a power source, install it and level it.
Cleaning it
Removing packaging materials
Remove tape and any inside labels (except
the model and serial number label) before
using the refrigerator.
To remove any remaining glue:
l Rub briskly with thumb to make a ball, then
remove.
OR
l Soak area with liquid hand-dishwashing
detergent before removing glue as
described above. Do not use sharp
instruments, rubbing alcohol, flammable
fluids or abrasive cleaners. These can
damage the material. See “Important
Safety Instructions” on page 3.
NOTE: Do not remove any permanent
instruction labels inside your refrigerator. Do
not remove the Tech Sheet fastened under
the refrigerator at the front.
Cleaning it before use
After removing all packaging materials,
clean your refrigerator before using it, if
necessary. See cleaning instructions on
pages 23-24.
Plugging it in
Recommended Grounding Method
A 220 or 240 Volt, 50 Hz., AC only 15 or
20 ampere fused and properly grounded
electrical supply is required. It is recom-
mended that a separate circuit serving only
this appliance be provided. Use a receptacle
which cannot be turned off with a switch or
pull chain. Do not use an extension cord.
See Electrical Requirements and Ground-
ing Instructions Sheet in your Literature
Package.