Filter
Top Products
Important
Do not discard dispenser trim or instructions.
Decorator Door Panel Installation Instructions
l/4” (6 mm) Panel Dimensions
2. Dispenser Models
Listed-below are required height x width dimensions for
decorator panels. Panels are not supplied with this kit and
can be purchased locally. Refrigerator panels should not
weigh more than 30 pounds and freezer panels should not
weigh more than, 15 pov& L
WI It-r t(
b,iVldZn4 ICI-IL
Refrigerator-Door Panel
Upper Freezer Door Panel
Lower Freezer Door Panel
General
63 3/32” x 19 310”
i a 3tw
x
i 3 3149’
31 9/l 6” x 13 3/4”
Remove crushed/cubed ice switch cover on dispenser
by placing taped edge of putty knife underneath cover
and pulling out. Release bottom clips on dispenser
cover by placing taped edge of putty knife underneath
cover and pulling out. Release top clips by holding
bottom of dispenser cover out and sliding up.
ul
(u
A
WARNING
Electrical Shock Hazard
Disconnect electrical power before installing panels.
Failure to do so can result in death or electrical shock.
Personal Injury Hazard
Wear gloves and protect arms when handling trim
pieces.
injury.
Failure to do so could result in cuts or other serious
L
3. Remove door handle inserts by placing screwdriver at
I I
top of door handles in area between handle and insert
and pulling forward. Pull edge of inserts forward along
-
length of handles.
’ I
Caution
To avoid property damage, protect soft vinyl or other
flooring with cardboard, rugs, or other protective
material.
Procedure
Important
Save all screws and reuse in original location.
1. Remove top handle end caps by removing screws.
A
WARNING
Failure to do so could result in personal injury.
4. Remove door handles by removing screws.
Important
Decorator panels should be cut to “l/4” panel dimensions.
Refer to “l/4” Decorator Panel Dimensions” section.