Filter
Top Products
Conversion
Converting to 1 P. gos
should be done by
a qualified installer.
Natural
A
Only a qualified
installer should
. .
install or
adjust your gas range.
Pressure Regulator:
Use a wrench to
unscrew the cao from
the top by turning counter-
clockwise. Turn the cap over so the hole
end is up. Replace the cap and gasket
on the regulator. DO NOT REMOVE THE
PRESSURE REGULATOR.
against pin. DO NOT OVERTIGHTEN.
Adjust the air shutters for proper flame by ’
sliding the air shutter to close or open the
shutter as needed. See Panel C. step 19
for electrical ignition systems or Step 20A
for standing pilot systems,
Cooktop burners with standing pilots
require adjustment of pllot flame to l/4
high. The adjustment control is located
on the manifold pipe or at pllot flame
base, depending on the model.
P
i”, _
Oven Burner: Remove oven
b.
racks and lower panel from
oven bottom. Turn the orifice hood
down until snug against pin. DO NOT
OVERTIGHTEN. Tne burner flame should
be l/2’ long when air shutter is correctly
adjusted. The air shutter slides to close or
open the shutter as needed. See Panel
C. Step 22 for electronic ignition systems,
or Step 24A for standing pilot systems.
Replace oven bottom and racks.
Standing Pilot System
(No thermostat adjustment
needed for electronic
ignition system.)
D
Oven thermostat: Remove
.
thermostat knob, pulling stiolght
off. Use a small screwdriver to rotate the
key to L.P. Replclce thermostat knob.
E
After all the burners have been
converted to L.P. gas usage and
gasyine is connected, check for leads.
Use a brush and liquid detergent to test
all gas connectlons for leaks. Bubbles
around connections will lndlcate a
leak. If a leak appears, shut off gas
valve controls and wrench-tighten
connections. Then check connectlons
again. NEVER TEST FOR GAS LEAKS WITH
A MATCH OR OTHER FLAME.
.i_
Prepared by Whrlpocl Cornorotlon. Genton Harbc’. ISilchlgan 49022
PrInted in U.S.A