Filter
Top Products
43
Dispenser Light (on some models)
Style 1
Reach through the dispenser area to remove and replace the
light bulb.
Style 2
The dispenser lights are LEDs which should not need to be
changed. If it appears that your dispenser lights are not working,
check to be sure that the light sensor is not blocked (in Night
Light mode). See “Troubleshooting” for more information.
Refrigerator Control Panel Light
Reach behind the refrigerator control panel to remove and
replace light bulb.
Crisper Lights
■ If necessary, remove the top crisper drawer to gain access to
the crisper light shield. Remove the light shield by lifting the
ends out of the brackets as shown.
■ Replace the light shield by inserting the ends into the
brackets. If necessary, replace the top crisper drawer.
Upper Freezer Light (on some models)
Style 1
■ Remove the light shield by grasping the top center of the
shield and pulling forward while turning it slightly to one side.
If necessary, remove the top crisper drawer to access crisper
light shield.
■ Replace the light shield by inserting the tabs on one end into
the slotted holes in the refrigerator or freezer liner. Then,
slowly bend the shield at the center to insert the tabs on the
other end.
Style 2
■ Remove the light shield by grasping the sides and squeezing
in toward the center and while pulling forward the shield.
■ Replace the light shield by fitting the tabs into the slotted
holes in the freezer liner. Push in the shield until it snaps into
place.
Lower Freezer Light (on some models)
Style 1 - Beneath Ice Bin
■ Remove the light shield by grasping the sides and squeezing
in toward the center. Once the side hooks of the shield are
free from the freezer lining, pull down the shield.
■ Replace the light shield by squeezing the sides toward the
center and inserting the shield side hooks into the slotted
holes. Once the side hooks are in place, snap the front tab
into the slotted hole.
Style 2 - Behind Freezer Basket
■ Depending on your model, remove the top freezer basket or
the top freezer basket shelf. Remove the light shield by
removing the Phillips screw on the top of the shield. Slowly
rotate the shield until the left tab can be gently pulled from
the freezer wall.
■ Replace the light shield by inserting the left tab into the
freezer wall. Align the top tab with the screw hole and replace
the screw.
A.Dispenser Light
A