Troubleshooting
Before calling for assistance please check the chart below for problems you can fix. It
could save you the cost of a service call.
Dishwasher problems
PROBLEM
CHECK THE FOLLOWING
Dishwasher does Is the door tightly closed and securely latched?
not run or stops
during a cycle
Has the cycle been set correctly? See the “Setting the Controls”
section.
Has a household fuse blown or circuit breaker tripped?
If the motor stopped because of an overload, it will automatically
reset itself within a few minutes. If it does not start, call for service.
Is the water SUDDIV turned
on?
Dishwasher
will not fill
Is the overfill protector stuck in ‘up” position? Overfill protector
should move up and down freely. Press down to release. See the
“Carina for Your
Dishwasher”
section.
Water remains
Allow cycle to finish. A small amount of water remainina is normal.
in dishwasher
Check the drain air gap (if installed). If it is clogged, follow the
manufacturer’s cleaning instructions.
Detergent remains
Has the cycle completed?
in covered section
of dispenser
Is the detergent fresh and dry without lumps? See the “Using the
Dispensers” section.
Is the bottom rack in backwards? The rack bumpers must face the
dishwasher door.
Dishes not as dry
Is the rinse agent dispenser empty? Using a rinse agent greatly
as you expected improves drying. See the “Using the Dispensers” section.
Do not use Air Dry option on the next load. See the “Setting the
Controls” section.
White residue
appears on front
of access panel
Is too much detergent being used? See the “Using the Dispensers”
section.
Dishwasher will
not close
Some liquid detergents develop excess foam and residue on panel.
Try a different brand to reduce foaming and eliminate buildup:
Is the bottom rack in backwards? The rack bumpers must face the
dishwasher door.
28