Filter
Top Products
Troubleshooting
Before calling for assistance please check the chart below for problems you can fix. It could
save you the cost of a service call.
Dishwasher problems
PROBLEM
Dishwasher does
not run or stops
during a cycle
Dishwasher
runs too long
Dishwasher
will not fill
Water remains
In dishwasher
CHECK THE FOLLOWING
Is the door tightly closed and securely latched?
Has the cycle been set correctly? See pages 13-l 4.
Is the dishwasher set for a delay start? See page 16.
Has a household fuse or circuit breaker blown or tripped?
If the motor stopped because of an overload, it will automatically
reset itself within a few minutes. If it does not start, call for service.
Is the water supply turned on?
Is the dishwasher wired into a live circuit with the proper voltage?
Cycle times depend on the temperature of the water entering the
dishwasher. Cooler water results in longer cycle times.
Undercounter dishwashers require adequate enclosure for proper
operation. See Installation Instructions for complete information.
Is overfill protector stuck in “up” position? Overfill protector should
move up and down freely. Press down to release. See page 19.
Allow cycle to finish. A small amount of water remaining is normal.
Check the drain air gap (if installed). If it is clogged, follow the
manufacturer’s cleaning instructions.
Detergent remains Has the cycle completed?
in covered section
of dlspenser
Is the detergent fresh and dry without lumps? See page 11.
Is the bottom rack in backwards? The rack bumpers must face the
dishwasher door.
Dishes not as dry
as you expected
Is the rinse agent dispenser empty? Using a rinse agent greatly
improves drying. See page 12.
Do not use Air Dry option on the next load. See page 15.
Grinding, grating,
Has a hard object entered the POWER CLEANTM module?
crunching, or
The sound should stop when the object is ground up.
buzzing sounds
White residue
Is too much detergent being used? See page 11 for recommended
appears on front
amounts of detergent.
of access panel
Some liquid detergents develop excess foam and residue on panel.
Try a different brand to reduce foaming and eliminate buildup.
Control panel does
Is the control panel Lock Out feature on? See page 17.
not respond when
pads are pressed
Is the door tightly closed and securely latched?
Dishwasher drains
Did you accidentally press the Cancel/Drain pad twice? Press
after turning off
Cancel/Drain pad again to stop draining.
indicators
Dishwasher will
not close
4
Is the bottom rack in backwards? The rack bumpers must face the
dishwasher door.