Filter
Top Products
Saving Energy
Saving energy is important and helps you save money. This section gives you tips on the
best ways to save energy with your dishwasher.
Loading tips
l Wash full loads. Running a half-filled
dishwasher uses the same amount of
electricity and hot water as a fully-loaded
machine.
l Load correctly for best washing results.
Incorrect loading may cause poor washing
and the need to rewash all or part of load.
l Do not prerinse normally-soiled dishes.
Select the correct cycle for the load
and use the recommended amount of
detergent.
Cycle and option tips
l Use the LOW ENERGY/CHINA cycle
l Use the LOW ENERGY RINSE option to
whenever possible. The cycle uses less
turn off the automatic water heating in the
hot water and energy than the NORMAL
final rinse.
cycle.
l Use the AIR DRY option whenever pos-
l Use 4 HOUR DELAY START to run your
sible. Allow longer drying times (overnight).
dishwasher during off-peak hours. Local
Use a rinse agent to improve drying.
utilities recommend avoiding heavy usage
of energy at certain times of day.
l Do not use the HIGH TEMP WASH option
if it is not needed. When this option is off, if
water entering the dishwasher is lower
than 140°F (607, the cycle does not take
additional time to heat water during the
main wash. In some cases, loads may not
dry as well when using the HIGH TEMP
WASH option.
NOTE:
Loads may not wash or dry as well
if the water temperature is too low. For
best dishwashing results, water must be
at least 120°F (49°C) as it enters the
dishwasher.
To check water temperature:
1.
Run the hot water at the faucet closest
to your dishwasher. Let the
water run for at least
1 minute.
2. Hold a candy or meat thermometer in
the running stream of water.
If water temperature at the
faucet is below 120°F (49”(Z),
have a qualified person raise
the water heater’s thermostat
setting.
19