Whirlpool 98012565 Range User Manual


 
10
Bakeware
The bakeware material affects cooking results. Follow
manufacturers recommendations and use the bakeware size
recommended in the recipe. Use the following chart as a guide.
Oven Vent
1. Oven Vent
The oven vent releases hot air and moisture from the oven, and
should not be blocked or covered. Doing so will cause poor air
circulation, affecting cooking and cleaning results. Never set
plastics, paper or other items that could melt or burn near the
oven vent.
Baking and Roasting
IMPORTANT: Never light the oven burner during a power failure.
Never place food or cookware directly on the oven door or the
oven bottom. When using the oven for the first time, it is
necessary to turn any one of the surface burners on first to
release air from the gas lines.
Before baking and roasting, position racks according to the
Positioning Racks section.
To Bake or Roast:
1. Touch BAKE.
Touch TEMP up or down arrow pads to set a temperature
other than 350°F (177°C) in 5°F (3°C) amounts. The bake
range can be set between 170°F and 500°F (77°C and
260°C).
2. Touch START/ENTER.
The temperature can be changed at any time after this step
by touching the TEMP up or down arrow pads. START/
ENTER does not need to be touched again. If baking/roasting
while the Timer is counting down, the set baking/roasting
temperature can be displayed for 5 seconds by touching
BAKE.
3. Touch OFF/CANCEL when finished.
Preheating
After START/ENTER is touched, the oven will enter a timed
preheat conditioning cycle. The HEAT, BAKE, and ON indicator
lights will light up. The Electronic Oven Control automatically
selects the conditioning cycle time based on the oven
temperature selected. The conditioning cycle time will not
change if the temperature is reset before the cycle countdown
ends. The preheat conditioning cycle is complete and the oven is
ready to use when a 1-second tone sounds, the cycle countdown
ends, and the set temperature is displayed.
Preheat temperatures are affected by varying factors such as
room temperature and peak energy usage times. It is normal for
the temperature showing on the display and the actual oven
temperature to differ.
Waiting an additional 10 minutes after the preheat conditioning
time ends to put food in the oven is suggested when baking
foods with leavening ingredients, such as yeast, baking powder,
baking soda and eggs.
Broiling and Custom Broiling
BROILER
The broiler is located below the oven door. The broiler pan and
grid roll out for easy access. Always broil with the broiler and
oven doors closed.
Do not step on or apply weight to the broiler door while it is
open.
Do not preheat broiler before use. Completely close broiler
door during broiling.
Do not use broiler drawer for storage.
Use only the broiler pan and grid provided with the appliance.
It is designed to drain juices and help prevent spatter and
smoke.
For proper draining, do not cover the grid with foil. The
bottom of the pan may be lined with aluminum foil for easier
cleaning.
Trim excess fat to reduce spattering. Slit the remaining fat on
the edges to prevent curling.
BAKEWARE/
RESULTS
RECOMMENDATIONS
Light colored
aluminum
Light golden
crusts
Even browning
Use temperature and time
recommended in recipe.
Dark aluminum
and other
bakeware with
dark, dull and/or
non-stick finish
Brown, crisp
crusts
May need to reduce baking
temperatures 25°F (15°C).
Use suggested baking time.
For pies, breads and casseroles, use
temperature recommended in
recipe.
Place rack in center of oven.
Insulated cookie
sheets or baking
pans
Little or no
bottom
browning
Place in the bottom third of oven.
May need to increase baking time.
Stainless steel
Light, golden
crusts
Uneven
browning
May need to increase baking time.
Stoneware
Crisp crusts
Follow manufacturers instructions.
Ovenproof
glassware,
ceramic glass or
ceramic
Brown, crisp
crusts
May need to reduce baking
temperatures 25°F (15°C).
1