Filter
Top Products
Removing the freezer shelf
(not on
RTI~EK)
To remove the shelf:
1. Lii front of shelf slightly.
2. Lit back of shelf off supports.
3. Replace in reverse order.
Using the ice cube trays
(on some models)
If cubes are not used, they may shrink. The
moving cold air starts a slow evaporation. The
longer cubes are stored, the smaller they get.
To remove Ice:
1. Hold tray at both ends.
2. Twist slightly.
Using the automatic ice maker
(Factory-installed on RT18BM, optional on other models)
lf you have an automatic ice maker, or if you plan
to add one later (Part No. IMKIT), there are a few
things you will want to know:
l
The ON/OFF lever is a wire signal arm.
Ralss
to make ice automatically.
signal
oh”
Down . . .
arm to
up . . .
to shut off the ice maker.
stop Its.
c”“*
Au
kc _--
. . .
NOTE: Do not Urn ice maker
cted to the wvons fux
I
4
are at
LOWW
I
to thahack of the
signal
arm to
8t8rt if
l
The dial or lever on the side of the ice maker
changes the size of the cubes.
l
Shake the bin occasionally to keep cubes
separated and to obtain increased storage
capacity.
l
lt is normal for ice crescents to be attached by
a corner. They will break apart easily.
l
You will hear water running when ice maker is
working. You’ll hear ice fall into the bin. Don’t
let these sounds bother you. They are part of
the normal operation of your refrigerator.
l
The ice maker will not operate until the freezer
is cold enough to make ice. This can take
overnight.
12