Filter
Top Products
GB
-2-
First time use
1- salt reservoir
2- rinse aid dispenser
3- detergent dispenser
4- racks system
5,6,7,8- available functions on the panel
9- filters
10- spray arms
In order to always ensure the best cleaning
results, you NEED to set:
DETERGENT type and WATER HARDNESS.
1.
Select 3rd programme
(see Table of programmes
- page 1)
2.
Press START button
for 7 seconds
3a.
Check your
detergent type...
3b.
...and set it on your dishwasher
using the START button
(as per table below)
4.
Remember to use salt and rinse
aid when needed (as indicated
below)
5.
Switch off and switch on
again to save setting
Detergent
types
Dishwasher models
model without
display
model with display
Powder or gel
(factory setting)
no symbol add salt add rinse aid
Tablet 2 in 1
add salt
Tablet 3 in 1
Tablet All in 1
For models without “detergent type” option, the salt and rinse aid indicators will be lit when tablets are used.
3h 6h 9h
rinse aid
salt
rinse aid
1.
Ask your water supply company what
the
water hardness
is...
2.
...enter this value on your dishwasher
Suggestions for detergent use
English
degrees °eH
Water
hardness
Dishwasher with
display: insert value
in the display
Dishwasher without
display: count
START button led
flashes
Gel or Powder
(rinse aid and salt)
Tablets
0 - 6.3 Soft 1 1x
go to step 1
(see “Daily check”)
if extra salt is
needed go to step 1
(see “Daily check”)
7 - 12.6 Medium 2 2x
13.3 - 18.9 Average 3 3x
19.6 - 25.9 Medium-hard 4 4x
26.6 - 35 Hard 5 5x
35.7 - 44.1 Very hard 6 6x
44.8 - 74.9 Extremely hard 7 7x
How to set water hardness
*
only
before the first wash
or if the
water hardness has been changed
Switch on the appliance
- Select the 2nd programme “P2” - consult the table of programmes.
- Press the START button for at least 5 seconds until the START indicator lamp flashes.
- The water hardness setting is shown on the display (if present) or the START button flashes.
- With each successive touch of the START button the setting increases and when it reaches 7 it returns to 1 again.
- The appliance must be switched off to memorise the new setting.
Even if you use tablets which include salt,
you must still add salt since such
detergents are not effective enough at
softening hard water.
Water hardness level is factory set for
medium hard water (a number “4” is
shown on the display or the START
indicator lamp flashes 4 times).
How to set detergent type: powder/gel/tablet (if option is available)