Filter
Top Products
SERVICE
19.07.2005 / Page 2 ADP 4300 WH Whirlpool Europe
Doc. No: 4812 728 11578 8511 764 43810 Customer Service
Technical data
Dimension
Height 82.0 - 87.0cm
Width 59.7 cm
Depth 55.5 cm
Weight 50 kg
Wooden door for Integrable types
Thickness min. 16 mm
Thickness max. 20 mm
Width min. 592 mm
Width max. 595 mm
Height min. 515 mm
Height max. 600 mm
Weight max. 5.5 kg
Max. stick out over lower
edge of appliance door 92 mm
Height of plinth min. 93 mm
Electronic boards
Service boards see spare part list
Serial boards see on the boards itself
Programmed control board and programing of
version , see „Board Service“ and „DATA“ on rating
plate of inner door:
UCB 704812
Data set 704802
Basic UCB, not programmed
see on the board itself 4619 727 04651
Succession of programs
Programs see program diagram
Succession P3a-P5b-P7a
Datas Energy Label
Reference program P5b
Energy Performance B
Cleaning Performance B
Drying Performance C
Program information
Start indicator
All programs will be locked after start. Changing
the program or finishing the program will be
possible only after pressing the start button for
longer then 1.5 sec. (Break by customer)
A switching off the appliance or unplug the
appliance for a while, this will frozen the program
step and later on, the program continuos on the
same position.
Exception: Switching off the appliance or unplug
the appliance during the drying phase, this will lead
directly to the end of the program.
Water Volume at permanent spray system
Water Volume Level
Regeneration 0.3 l 15 mm
Back rinse 3x 1.0 l 60 mm
Prewash 4.8 l 120 mm
Main wash 4.2 l 118 mm
Intermediate rinse 1 4.2 l 118 mm
Intermediate rinse 2 4.2 l 118 mm
Clear rinse 4.2 l 118 mm
Safety/ overflow 8.5 l 141 mm
Measuring the level
Remove the coarse sieve, put in a measuring
meter into the sump, measure the hight of the
water level.
Detergent max.
Pre-wash 10 cm
3
Main-wash 40 cm
3
Rinse aid 135 cm
3
6 Dosage steps 1 - 6 ml
Water softener
Saltcontainer 2 kg
Resin container 700 cm
3
Regeneration dosage 300 cm
3
Water pressure
Inlet pressure 0.3 - 10 bar
Spray pump pressure 0.3 bar
Rotations
Spray pump motor 2800 RPM
Drain pump motor 3000 RPM
Spray arm lower 30 - 40 RPM
Spray arm upper 30 - 40 RPM