Filter
Top Products
The dishes were not
loaded correctly .
See notes in " Load ing the Dis hwasher Basket s ".
Select a more intensive programme.
See" Wash Cycle Table ."
Use more detergent, or change your d etergent.
Rearrange the items so th at the sp ay can rot ate freely.r
Clean and/or fit the filter combination correctly.
Clean the sp ay arm jets. See "Cleaning the Spray
Arms".
r
Use less detergent if you have soft water and select
a shortest cycle to wash the glassware and to get
them clean.
Use a mild abrasive cleaner to eliminate those marks.
Re-loading the dishes properly.
Load the dishwasher as suggested in the directions.
Increase the amount of rinse-aid/refill the rinse-aid
dispenser.
Do not empty your dishwasher immediately after
washing. Open the door slightly so that the steam can
escape. Begin unloading the dishwasher only on ce t
he dishes are barely warm to the touch. Empty the low
basket first. This prevents water form dropping off
dishes in the upper basket.
In short program the washing temperature is lower.
This also lowers cleaning performance. Choose
a program with a long washing time.
Water drainage is more difficult with these items.
Cutlery or dishe s of this t ype are not suitable for
washing in the dishwasher.
The programme was
not powerful enough.
Not enough detergent
was dispensed.
Items are blocking
the path of spray arms.
The filter combination
inthebaseofwash
cabinet is not clean or
is not correctly fit t ed.
This may cause
the sp ay arm jets
to get blocke d.
r
Combinat ion of soft
water and too much
detergent.
Aluminum utensils
have rubbed against
dishes.
Dishes block
detergent cups.
Improper loading
Too little rinse-aid
Dishes are removed
too soon
Wrong program
has bee n selected
Use o f cutlery with
a low-quality coating
Error Codes
Tap is not opened, or water intake is restricted,or water pressure
is too low.
Malfunctio n of temperat ure sensor or of heating element.
Too much inlet water.
Short circuit or break of temperature sensor
Open circuit or break of temperature sensor
Long er inlet time.
Longer heating time,
but not reaching required temperature
Ove rfil led .
Failure of te mperature s ensor
Failure of te mperature s ensor
When s ome malfunctions come o n, the appliance will display error cod es to warn you:
WARNING!
If ove rflow occurs, turn off the main water supply before ca lling a service.
If there is water in the base pan because of an overfill or small leak,
the water sh ould be remove d before restarti ng the dishwa sher .
20
Uns a ti s
-factory
was hin g
res u lt
Uns a ti s
-factory
dry i ng
res u lt