Whirlpool AKZ 162 Appliance Trim Kit User Manual


  Open as PDF
of 36
 
INSTALLATION - 70CM
METHOD 2: HOUSING UNIT WITH
INTERNAL HEIGHT LESS THAN
710MM
Note: You will not need the 2 side trims
(687mm long) or the appliance runners
for this installation. You will need the 2
runnerstoxtotheadjacentcabinets.
Before you start;
Before removing the bottom shelf or
modifying the housing unit, make sure
that it will remain structurally sound, eg;
byxingtoadjacentcabinets,ooror
worktop.
You may have to cut into or remove any
rear cross members to obtain the 550mm
minimum depth.
To obtain the required 710mm height, you
may have to lower or remove the bottom
shelf - remove any cross rails and reposi-
tion brackets.
Toxtherunners(ifrequired)
1. Take the side trims, hold it against the
side of the base unit, and use it to mark
off the 687mm from the top edge of the
side unit, to the top edge for the runner.
Note: This ensures a 5 - 8mm clearance
from the underside of the worktop to the
top of the appliance.
2. Measure 50mm from the front edges of
the base units, to mark the front edge for
the runners.
3. Take 6 of the No 8 x 12mm (Black)
chipboard screws and screw the runners
into position the right way up as shown.
4. If necessary, adjust the height of the
plinth to just below the bottom edge of
the runners.
Ifyourequireareplacementxingkit
please call the customer care helpline and
order part number 01 28287 00.
 previous next