Filter
Top Products
A “en shows what steps are in each cycle
Cycle
Main
Time
Cycle Wash Rinse Wash Rinse Rinse Dry (Minutes)
Light Wash
A single wash for
pre-rinsed or lightly
soiled loads.
NOTE: The Cycle Control knob
does not move while the dishwasher
heats water to 135°F (57°C) in the
final rinse (marked +). If the Hi-Temp
Wash option is selected water will
also be heated in the main wash
(marked n). See page 10.
.I-+
.
l t
.
60’
Rinse & Hold
q For rinsing a few items
sib
to be washed one or
more days later. Do not
use detergent. Drying with heat may
cause food to bake on dishes.
. .
16
*Cycle time includes heated dry time. Cycle time may vary depending on the temperature of
the water entering the dishwasher.
What happens in each option
Hi-Temp Wash option
If the Hi-Temp Wash option is selected,
water is heated in the dishwasher during the
main wash of the Heavy Wash, Normal
Wash and Light Wash cycles to improve
washability. The Hi-Temp Wash option is
automatically selected for the Pots 8 Pans
cycle. See “Cycle selection chart” on pages
9 and 10.
NOTE:
l
The DELAY/WATER HEATING signal light
will glow while the water is heating.
l
The Cycle Control knob does not move
while the water is heating.
. The Cycle Control knob will begin moving
again when the water temperature reaches
135°F (57°C).
l
The heating time is based on the tempera-
ture of the water supply as it enters the
SELECT
dishwasher. The cooler the water, the
longer the heating time.
If water temperature at the faucet is below
120°F (49”C), have a qualified person raise
the water heater’s thermostat setting. See
page 14.
l
The dishwasher does not pause to heat the
water if the water entering the dishwasher
is already 135°F (57°C).
10