Whirlpool DP3880XM Dishwasher User Manual


 
Option Selector Switch
Before starting your dishwasher
1. Spin the Upper Spray Arm to make
sure nothing will stop it from turning
freely.
2. Close and latch the door.
3. Run hot water at sink nearest dish-
washer until it is hot. Turn it off. (See
page 10 for connecting instructions.)
Starting your dishwasher
NORMAL HEAVY Cycle...
1. Make sure Cycle Control Knob points
to dot marked NORMAL HEAVY.
2. Select option.
3. Without turning it, pull the Cycle Con-
trol Knob out to start the Cycle.
NORMAL LIGHT Cycle...
1.
Turn Cycle Control Knob until it stops
RINSE & HOLD Cycle...
at dot marked NORMAL LIGHT.
1.
Select AIR DRY Option only.
2. Select option.
2. Uniatch door and open slightly.
3. Pull Cycle Control Knob out.
3. Without turning it, pull the Cycle Con-
4. Turn Control Knob clockwise to dot
trol Knob out to start the Cycle.
marked RINSE & HOLD.
5. Close and latch the door to start the
cycle.
Changing a setting
2. With the Cycle Control Knob
pulled out,
You can change a setting anytime during
turn clockwise to the cycle you want.
any cycle.
3. Be sure the detergent dispensers are filled
1. Unlatch the door to stop the cycle.
properly for the new cycle.
4. Latch the door to start the cycle.