Filter
Top Products
r -~ ------
----- - -
A special adapter must be installed on the faucet before the dishwasher can
be connected. Complete Instructions and the adapter are packed wlth your
dlshwasher.
When moving your dishwasher, make sure
the door is latched. Use the built-In pull bar or
hold it at the top front corners.
Before starting
1. Run water at faucet until it is hot. Turn it off.
PULL RING
2. Pull hoses out of their storaae compartment
on the back.
CKING COLLAR
3. Pull down on the locking collar while lifting
the hose connector onto the faucet adapter.
4. When the connector snaps into place, re-
lease the locking collar.
5. Turn the hot water on slowly until it is all the
way on.
6. Plug in power supply cord.
7. See pages 8 and 9 to start the dishwasher.
While dishwasher is running
You can draw water from the faucet while the
dishwasher is connected. DO NOT draw water
while the dishwasher is filling or while water is
being pumped out. (This helps prevent a low fill
when dishwasher is filling, or mixing drain water
with fresh water,]
1. Press red button on hose connector to get
the water you want. (The faucet is set on hot.
Adjust faucet forthe water you want.)
2. Be sure you return cold water to off, and
that hot water Is tull on.
When cycle is finished
1. Turn hot water off. (This can be done after the
last rinse.)
2. Press the red button on the connector to re-
lease the water pressure.
14
3.
4.
5.
6.
Llft slightly on the hose connector while puil-
ing down the locking collar. Pull down on
the connector.
Empty any remaining water from the
connector.
Unplug power supply cord and return to
storage compartment.
Return hoses to storage compartment.
Electrical Connection
A power supply of 120 volts, 60Hz AC only, 15
amps, is required. For your personal safety, this
appliance must be grounded. This appliance
is equipped with a power supply cord having
a 3-prong grounding plug. To minimize possi-
ble shock hazard it must be plugged into a
mating 3-prong grounding type wail recepta-
cle, grounded in accordance with the Na-
tional Electrical Code and local codes and
ordinances. If a mating wall receptacle is not
available, it is the personal responsibility and
obligation of the customer to have a properly
grounded 3-prong wail receptacle installed
by a qualified electrician. DO NOT use an ex-
tensionggy
DO NOT, UNDER ANY CIRCUMSTANCES, RE-
MOVE THE POWER SUPPLY CORD GROUND
PRONG.
Converting to built-in
Your Whirlpool Portable Dishwasher can be
converted to a built-in (undercounter) model
by using conversion kit No. 569056. The kit is
available at your Whirlpool dealer or autho-
rized TECH-CARE@ Service Company. Instruc-
tions are included with the kit.
Caring for
simulated wood top
The simulated wood top can be used as a
utility work surface for most kitchen jobs. it is
stronger and more easily cleaned than genu-
ine wood.
The top can be used as a cutting board. Knife
marks will be visible but will not seriously dam-
age top. Hot items from the oven can be placed
on the top.
Clean with warm, soapy water. For dried on
foods, use a scouring pad.