Filter
Top Products
Before starting
your dishwasher
1. Spin the Upper Spray Arm to make sure
nothing will stop it from turning freely
2. Push door firmly when closing and it will
automatically latch.
3. Run hot water at sink nearest dishwasher
until it is hot. Turn it off.
Starting your dishwasher
. #
CLEAN SELECTOR BUlTONS
POTS & PANS cycle...
NORMAL WASH cycle...
1. Push POTS & PANS Clean Selector Button.
2. Push button for option desired.
3. Turn Cycle Control Knob clockwise to
dot marked POTS & PANS.
- POTS % PANS and NORMAL WASH Cy-
cles share the same spot on the dial.
The Clean Selector Button determines
which cycle operates.
The dishwasher will automatically start
that cycle.
LIGHT WASH cycle...
1. Push LIGHT WASH Clean Selector Button.
1. Push NORMAL WASH Clean Selector
Button.
2. Push button for option desired.
3. Turn Cycle Control Knob clockwise to
dot marked NORMAL WASH.
- NORMAL WASH and POTS % PANS Cy-
cles share the same spot on the dial.
The Clean Selector Button determines
which cycle operates.
The dishwasher will automatically start
that cycle.
RINSE & HOLD cycle...
-LIGHT WASH and NORMAL WASH Cycles
share the same Clean Selector Button.
The Control Knob setting determines
which cycle operates.
2. Push button for option desired.
3. Turn Cycle Control Knob clockwise to
dot marked LIGHT WASH. The dishwasher
will automatlcally start that cycle.
1. Push NORMAL WASH Clean Selector
Button.
2. Select AIR DRY Option
only.
3. Turn Cycle Control Knob clockwise to
dot marked RINSE % HOLD. The dish-
washer will automatically start that
cycle.
HEAT DRY or AIR DRY?
save energy, but dishes take longerto dry (over-
night] and-some water spotting may- result.
Some items (such as plastics] may need towel
drying.
For best results, use a liquid rinse aid such as
Jet-Dr)F
If the
HEAT DRY Option
is selected, air in the
dishwasher is heated during the “dry” part of
the cycle.
If the
AIR DRY Option
is selected, air in the
dishwasher is not heated. Using this option helps
To add a dish after starting
4. Close
the door.
Do not latch it.
Wait 30 sec-
1.
To be sure the added item is washed and
rinsed, make sure the Cycle Control Knob
onds for air in the dishwasher to warm up. This
has not passed LIGHT WASH.
helps reduce the amountof moisture thatcan
come from the vent when restarting the
2. Push up on door latch to unlatch door and
stop the cycle.
3. Open the door and add the dish.
cycle.
5. Press in door to latch it. The dishwasher will
start where it stopped.